So I ordered the motozaaa scrambler kit for my 500 and just wasn’t feeling the height of the seat or the plastic panels that come with the kit so I decided to drop the seat quite a bit and make my own panels. This means I would have to mod the seat and frame of the bike, but it’s not as hard as you would think. I’ll drop a picture down below of the build so far! Let me know what you guys think.
Scrambler build
Scrambler88
21 - 23 of 23 Posts
So I don't wanna be "That Guy".
But Passenger pegs? Even if the bike holds up with that steel brace cut.( I know you said you added a brace) There doesn't seem to be enough room on that seat for a passenger. I could be wrong but it looks like it is only about 6 inches further back than the stock main seat. Have you tried fitting 2 people on it? Many have already complained that the passenger pegs were causing leg pain for passengers because of their posistion and this would make that even shorter.
But Passenger pegs? Even if the bike holds up with that steel brace cut.( I know you said you added a brace) There doesn't seem to be enough room on that seat for a passenger. I could be wrong but it looks like it is only about 6 inches further back than the stock main seat. Have you tried fitting 2 people on it? Many have already complained that the passenger pegs were causing leg pain for passengers because of their posistion and this would make that even shorter.
Joined
·
15 Posts
Looks awesome! What I don't understand though is, where does the license plate go? I love the smaller fender look also, but I can't figure out where the license plate would go!
It looks like he has one of those vertical plate bracket on the drive side. It's hard to see because of the angle, but it's there. Depending on your country/state/province, this is something that can be perfectly legal, illegal but tolerated, or just the most obvious cop magnet you possibly could bolt on your motorcycle.
21 - 23 of 23 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
