Honda Rebel 300 & 500 Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
After about a year, I have finally decided to change my brick.
Without splicing the harness. All new wires, and connectors.
Unfortunately, California's License Plate is either too big, or Japan's Plate is too small. Currently my plate is zip-tied onto the mount.

Parts List:
Taillight https://japan.webike.net/products/23619207.html

Turn Signals https://www.revzilla.com/motorcycle/lightech-led-turn-signal-type-6

22awg wire 20ft https://www.amazon.com/Electrical-Gauge-Silicone-Cable-Black/dp/B0746HG158/ref=pd_ybh_a_8?_encoding=UTF8&psc=1&refRID=BZC3QEV38ZWW6K6BSZP7

CustomLED 2pin Turn Signal Connector https://www.customled.com/products/honda-oem-turn-signal-connectors-2-wire

CustomLED Honda LED Flasher Relay https://www.customled.com/products/elfr-1-h-electronic-led-flasher-relay-4-pin-honda

Lots of heat shrink (I had bulk from work that I was able to use)
 

Attachments

·
Registered
Joined
·
1,328 Posts
I have a backer plate made out of 14 gauge steel that my license plate is fastened to and then the backer plate is fastened to the motorcycle.

Kenny G
 

·
Registered
Joined
·
41 Posts
Hey @RussianBear365, I was about to give up after 3 days of internet searching for a new tail light and finally did one more search on here and found your post...! My problem is most of the tail lights replacements are too small and this one fits the bill so well. Think I'll order it.

How did you end up attaching it to the fender? I can't tell if the bolt holes match the pre-existing ones.
 

·
Registered
Joined
·
226 Posts
The Daytona light from Webike Japan is a plug and play replacement for the original tail light. Uses the same 2 holes as the original bracket.


Hey @RussianBear365, I was about to give up after 3 days of internet searching for a new tail light and finally did one more search on here and found your post...! My problem is most of the tail lights replacements are too small and this one fits the bill so well. Think I'll order it.

How did you end up attaching it to the fender? I can't tell if the bolt holes match the pre-existing ones.
 

·
Registered
Joined
·
226 Posts
I would have posted a closeup pic of mine but did not want to hijack the OP's thread.
Just a heads-up, the instructions are in Japanese.


Thanks for that, I actually just ordered it about 5 minutes ago and was checking back on the thread here, so great timing. Can't wait to put it together with the rear signals I got to.
 
1 - 12 of 12 Posts
Top