Honda Rebel 300 & 500 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter #1
Hey all, I've added some halogen Oxford Mini rear signals by splicing them into the existing wiring with new female bullets to accept the connection.

I'm confident in my crimping and wiring, but there is some issue and the circuit is no longer closed and cannot operate the front or rear blinkers. I've checked the fuses and front signal connection and all is good. I'm connecting the black ground wire from the signal to the correct green wire as well. Aside from the possibility the new signals are defective, is there any other issue someone can think of?

I will add I haven't crimped the connections together yet, but I figure this shouldn't be an issue as there is full surface contact between the male and female bullets.

Thanks in advance for any ideas.
 

Attachments

·
Registered
Joined
·
75 Posts
Discussion Starter #3
Do the old lights still work when plugged in?
Great thought and would have, but unfortunately I cut them off. Originally I was going to splice on the new ones, but have ended up installing a new set up completely.
 
1 - 3 of 3 Posts
Top