Honda Rebel 300 & 500 Forum banner

21 - 25 of 25 Posts

·
Registered
Joined
·
302 Posts
Discussion Starter #23 (Edited)
@Verdesardog . Posted here so it won’t get cluttered. This is how I did it. notice, I placed washers and large nut to raise the front end just enough so when I sit, I don’t slide forward. Look at the gap from the front of the seat and the gas tank. I cut a small portion of the rear pan so the seat will slide back some. Careful not too much because you want the pan to slide under The cover .see photo. I used larger washer to attach the spring To the plate. When installing washers, for the first time, since it’s a trial and error to get the right raise, cover the air box inlet so washers won’t accidentally fall inside . Nest time I will have the front assembly tack welded so the seat comes off as a unit
32554
32555
32556
32557
32558
32559
32560
 

·
Registered
2019 Rebel 300
Joined
·
87 Posts
Thanks! Looks like your seat is longer than mine and the springs are shorter. Maybe if I get some shorter springs????
Are you Filipino? pogi in tagalog means good looking LOL
 
21 - 25 of 25 Posts
Top