Honda Rebel 300 & 500 Forum banner

1 - 20 of 42 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
Hey guys, how’s it going ?

just wanted to share my daily rebel and my rebel project.


my daily is a ‘85 rebel 250 that made into a little bobber

31805


31806


31807
 

·
Registered
Joined
·
33 Posts
Discussion Starter #2
My project as of lately is a 1986 rebel roller and putting a 2009 Kawasaki ninja 250 6spd watercooled motor on it.

31808
31809
31810
31811
31812
31813
 

·
Registered
Joined
·
33 Posts
Discussion Starter #5
how much frame mod did you have to do to strap that ninja motor in there?
not much, had to cut every single stock mount and tabs off rebel frame. Motor fit after that . Then realized carbs didn’t wanna fit so then had to trim a little under top tube to get them to fit.


next thing I have to do is make some mounts for the ninja motor n weld them to frame, just going to use some square metal, drill hole for bolt to go through, weld other side to frame and then I can use a sharpie and shape them to my liking


31820
31821
 

·
Registered
Joined
·
33 Posts
Discussion Starter #6
Capped off the stupid emission stuff, not sure if it’s clean air solenoid or air injection but it’s gone.

capped it off and then trimmed the line off the carbs that went to it and threw a screw in it to block off and have no vacuum leak
31822
31823
31824
 

·
Registered
Joined
·
33 Posts
Discussion Starter #7
Then have to grab some heater core line from parts store, to be able to mock up radiator
just zip tied At moment

31825
31826
31827
31828
31829
 

·
Registered
Joined
·
33 Posts
Discussion Starter #19
Tried to fire it up , gotta clean or rebuild the carbs. Either floats r sticking or the o rings in the connector attaching them together is leaking . But it turned over and tried to start!
 
1 - 20 of 42 Posts
Top