Frame Slider Pin's ( long steel rod's with caps ) would be great,but I haven't seen any after-market, same for on the front and rear axle,
I don't care about the engine, I just hate to have my leg/ankle crushed when the bike goes down.
I agree these HUGE monkey cages look terrible, and they're not strong, they're just light pipes that wrap the engine, not sure what they would accomplish? They're cheap at $100
I would prefer to find a rock solid ( +1" round ) steel tube that sticks out both sides as wide as the lower foot peg, usually they pass though the lower motor-mount, and for the front they kit just replaces the front axle. The rear you get a lift-kit for fast-jack that includes the sliders,
Why nobody is selling this KIT for the Rebel boggles my mind, I guess it can only be that the MARKET is near zero for sales potential,
Probably going to have to make my own, or get another set for a similar bike and rethread/weld and ot what it takes, but I see no point of the MONKEY-CAGE around the engine.